If your Glocks were test-fired in 2008 or earlier, I would hold on to the old extractors because the old ones were investment cast and in my opinion better quality, the new ones are supposedly MIM. Most cases of erratic ejection are fixed by a "Gen4" ejector and/or a replacement extractor. You may also need a replacement extractor. Here's a thread that goes a little more into detail about swapping ejectors: You must remove the trigger housing from the frame before swapping ejectors. Also DO NOT try to pull the ejector out of the trigger housing while the trigger housing is still in the frame, part of the frame covers the bottom of the ejector and you will likely damage the frame. (Gen1's and Gen2's use the same trigger housing as Gen3's) I wrapped the teeth of the pliers in masking tape so as not to scratch or gouge the ejectors.
GLOCK GEN 4 EJECTOR FREE
You can't use a Gen4 trigger housing in a Gen3, so you'll need to remove the Gen3 trigger housing from the frame, pull the ejectors out of each trigger housing with a pair of pliers, then insert the "Gen4" ejector into the Gen3 trigger housing and re-install the Gen3 trigger housing into the Gen3 frame. Glock OEM Gen 4 Trigger Housing w/ Ejector (30274) 9mm 17 19 26 34 30275 Brand New 17.95 Buy It Now Free shipping 54 sold Sponsored Glock Trigger Housing Oem Gen 3 w/ Gen 4 Ejector 9mm, Connector, Spring SP30274 Brand New 47.66 5 off 99+ with coupon Was: 52. Other retailers may have older stock that still have the old 336/1882 ejectors, but again I haven't checked in a long time so most retailers probably have the newest ones. I haven't checked in a while but I know that 9mm Gen4 trigger housings from, , and have the 30274 ejector.40/.357 Gen4 trigger housings from have the 28926 ejector. Currently they're used in Gen4's, and you can get them in the newest Gen4 9/40/357 trigger housings. I'm surprised that Glock has not started using the new ejectors in Gen3's as well. The 28926 ejector fixed it, the dents/scrapes are gone and they all eject to the right now. The replacement extractor alone made a tiny difference, but it was still denting/scraping the case mouths of the spent casings and some were still going over my head. 40 28926 ejector into the Gen3 trigger housing of that gun, and using a replacement extractor as well. My Gen3 G27 ejected erratically and I fixed it by installing a "Gen4".
I've seen videos that show erratic ejection in Gen2's so it seems this is something that has always existed in Glocks, but it appears to have become much more common in recent production.
0 kommentar(er)
